How to set up iHub only
1 In the setupiHub menu, choose option 3, Set up iHub only.
The script performs the following tasks, as shown in
Figure 6‑17:
Installs the prerequisite C++ run‑time components
Sets up the iHub deployment files, including log and security keys files
Sets up and starts BIRT iHub 2
Figure 6‑17 Completing the iHub‑only setup
When the script starts iHub, a new command prompt opens to function as the Actuate BIRT iHub console from which iHub can be shut down, as shown in
Figure 6‑18.
Figure 6‑18 Viewing Actuate BIRT iHub 2 console
When the script finishes running, a browser opens displaying Welcome to Actuate Information Console, as shown earlier in
Figure 6‑7, but no Encyclopedia volume is available. You cannot log in to Information Console until an Encyclopedia volume exists.
2 After the script finishes running, press any key to close the command prompt running setupiHub.bat script, as shown in
Figure 6‑17. If the script exit returns to the command line, type exit to close the command prompt.
3 After installing option 3, stop and restart iHub by performing the following tasks:
1 In Actuate BIRT iHub console, type s to shut down BIRT iHub.
2 Open a new command prompt and navigate to AC_SERVER_HOME/bin.
3 Type the following command and press Enter, as shown in
Figure 6‑19:
startsrvr
Figure 6‑19 Starting Actuate BIRT iHub 2
A new Actuate BIRT iHub 2 console opens, as shown earlier in
Figure 6‑18. This window must remain open, since the iHub service runs from this window. For more information about stopping and starting iHub, see
“How to stop and start Actuate BIRT iHub,” earlier in this chapter.
